Hi Lori
It sounds like a case of Zlob/DNSchanger that change the router's DNS settings
Malwarebytes' Anti-Malware- Open Malwarebytes' Anti-Malware
- Select the Update tab
- Click Check for Updates
- After the update have been completed, Select the Scanner tab.
- Make sure the "Perform full scan" option is selected.
- Then click on the Scan button.
- If asked to select the drives to scan, leave all the drives selected and click on the Start Scan button
- The scan will begin and "Scan in progress" will show at the top. It may take some time to complete so please be patient.
- When the scan is finished, a message box will say "The scan completed successfully. Click 'Show Results' to display all objects found".
- Click OK to close the message box and continue with the removal process.
Back at the main Scanner screen:
- Click on the Show Results button to see a list of any malware that was found.
- Make sure that everything is checked, and click Remove Selected.
- When removal is completed, a log report will open in Notepad and you may be prompted to restart your computer. (see Note below)
- The log is automatically saved and can be viewed by clicking the Logs tab in MBAM.
- The log can also be found here:
C:\Documents and Settings\Username\Application Data\Malwarebytes\Malwarebytes' Anti-Malware\Logs\mbam-log-date (time).txt - Copy and paste the contents of that report in your next reply and exit MBAM.
Note: If MBAM encounters a file that is difficult to remove, you will be presented with 1 of 2 prompts. Click OK to either and let MBAM proceed with the disinfection process. If asked to restart the computer, please do so immediately. Failure to reboot will prevent MBAM from removing all the malware.===============================================Next you must reset the router to its default configuration. This can be done by inserting something tiny like a paper clip end or pencil tip into a small hole labeled "reset" located on the back of the router. Press and hold down the small button inside until the lights on the front of the router blink off and then on again (usually about 10 seconds). If you don’t know the router's default password, you can look it up
HEREChange the router's default password after reset to prevent reinfection. This is especially important if the router is wireless.
However, if there are other Zlob-infected machines using the same router, they will need to be cleared with the above steps before resetting the router. Otherwise, the malware will simply go back and change the router's DNS settings. You also need to reconfigure any security settings you had in place prior to the reset. Check out
this site here for video tutorials on how to properly configure your router's encryption and security settings. You may also need to consult with your Internet service provider to find out which DNS servers your network should be using.
Once you have ran Malwarebytes' Anti-Malware on the infected system, and reset the router to its default configuration you can reconnect to the internet, and router. Then return to this site to post your logs.
Please post the Malwarebytes log and let me know how things are running now.